Knowledgebase
Solution for "Error 1935.An error occurred during the installation of assembly 'Microsoft.VC80.ATL..."
Posted by Nico Wang on 04 March 2016 03:17 PM

Symptoms: If you receive a 1935 error (shown as below) when you try to install the software.

Cause: It’s probably caused by the third party software included the Appeon Developer.

Solutions: Kindly please try the following steps to change the registry to resolve it.

a. Type regedit in the start search box.

b. In the Registry Editor window, navigate to HKEY_LOCAL_MACHINE > SYSTEM > CurrentControlSet > Control.

c. In the Registry Editor, dialog box, double-click RegistrySizeLimit. This opens the Edit DWORD Value dialog box.

d. In the Edit DWORD Value dialog box, enter ffffffff as the Hexadecimal value. Click the 'Decimal' radio button, and enter 4294967295 as the Decimal value. Click OK.

e. Reboot the machine.

f. Log in as an Administrator and open a Command Prompt and type SFC /SCANNOW. This may take a while.

After the process is completed, re-install the software.

Important: Serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. So you can restore the registry if a problem occurs.

(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Post a new comment 
 

Please login if you wish to leave a comment about this article.

Help Desk Software by Kayako Fusion